Product Info
Table Of Contents
- VISTA HD Wearable Camera User Guide
- Important Notice
- Contents
- Introduction
- Using the VISTA Body Camera
- Overview
- Wearing VISTA and VISTA WiFi
- Wearing VISTA XLT
- Powering On and Off
- Starting and Stopping a Recorded Event
- Muting the Audio During a Recorded Event
- Categorizing a Recorded Event
- Docking the VISTA Body Camera
- About the VISTA Body Camera
- VISTA Body Camera Special Features
- Using VISTA WiFi or VISTA XLT with a Recording Group
- Appendix A: Using VISTA SmartConnect
- Appendix B: Using the QuickConnect Mobile Charger
- Appendix C: Upgrading VISTA, VISTA WiFi, and VISTA-Related Devices
- Appendix D: VISTA Transfer Station Setup
- Index
Upgrading the VISTA WiFi Base and the Smart Power Switch
Upgrading the VISTA WiFi Base and the Smart
Power Switch
When upgrades are available for the VISTA WiFi Base and the Smart Power Switch, the
upgrades are included with the VISTA Body Camera upgrade. Once the camera has been
upgraded, the next time it is docked in the WiFi Base, it makes the base and switch upgrade
packages available.
For information on upgrading the VISTA Body Camera, see Upgrading firmware on page 48.
Note: Typically, WatchGuard releases upgrades for the camera, the WiFi Base,
and the Smart Power Switch at the same time.
To upgrade the VISTA WiFi Base and the Smart Power Switch:
1. Dock the upgraded camera in the WiFi Base and allow it to pair with the base.
The base's left LED blinks green multiple times when the camera and base are paired.
2. Wait while the camera stages any video it has stored.
When the camera has finished staging its video, it blinks its red LED multiple times.
Note: The amount of time the camera needs to stage its video depends
on how much video is stored on it.
3. After the camera has finished staging video, wait about 4 minutes for the base to download and
stage its upgrade package then the switch's upgrade package.
As the base begins to download and stage its own upgrade package, the base's left
LED blinks between green and yellow very quickly.
Once the base has fully downloaded and staged its own package, it begins
downloading and staging the package for the switch. At this point, the base's left LED blinks
between green and yellow more slowly.
Once the switch's package is fully downloaded and staged, the base's left LED turns
solid green.
4. Once the base's left LED turns solid green, you can use the camera normally.
Important! Make sure you maintain power to the system while the upgrades
are being downloaded and staged.
The next time the WiFi Base and the Smart Power Switch are restarted, their staged upgrades
are applied. New functionality included in the upgrades only becomes available once the
upgrades are applied.
VISTA Body Camera
WGD00120 Revision
ReviewDraft_070819
129
Draft