Product Info
Table Of Contents
- VISTA HD Wearable Camera User Guide
- Important Notice
- Contents
- Introduction
- Using the VISTA Body Camera
- Overview
- Wearing VISTA and VISTA WiFi
- Wearing VISTA XLT
- Powering On and Off
- Starting and Stopping a Recorded Event
- Muting the Audio During a Recorded Event
- Categorizing a Recorded Event
- Docking the VISTA Body Camera
- About the VISTA Body Camera
- VISTA Body Camera Special Features
- Using VISTA WiFi or VISTA XLT with a Recording Group
- Appendix A: Using VISTA SmartConnect
- Appendix B: Using the QuickConnect Mobile Charger
- Appendix C: Upgrading VISTA, VISTA WiFi, and VISTA-Related Devices
- Appendix D: VISTA Transfer Station Setup
- Index
Using the VISTA Body Camera
Helmet mounts
WatchGuard has two versions of the helmet mount, one designed for the top of the helmet,
one for the side. Both use the same base bracket.
Important! Placing the mount in a location on the helmet other than where it
was designed to be placed (top or side) will cause your video to be recorded in the
wrong orientation (sideways).
Placing the bracket
The bracket for the helmet mounts is designed to permanently attach to the helmet. The
adhesive on the bracket can only be attached once.
Select a bracket location on the helmet where:
l Helmet surface is mostly flat
l Camera will point forward with the Record Start/Stop button on the top
l Mount/camera/cable assembly will not interfere with any helmet moving parts (visor, vent
control, etc.)
l Removal of the mount clip/camera assembly from the bracket and/or the cable from the
camera will allow you to remove your helmet
Tip: Use double-sided tape to test the placement of the helmet mount before
you remove the adhesive backing on the bracket.
28
VISTA Body Camera
WGD00120 Revision
ReviewDraft_070819
Draft