Product Info
Table Of Contents
- VISTA HD Wearable Camera User Guide
- Important Notice
- Contents
- Introduction
- Using the VISTA Body Camera
- Overview
- Wearing VISTA and VISTA WiFi
- Wearing VISTA XLT
- Powering On and Off
- Starting and Stopping a Recorded Event
- Muting the Audio During a Recorded Event
- Categorizing a Recorded Event
- Docking the VISTA Body Camera
- About the VISTA Body Camera
- VISTA Body Camera Special Features
- Using VISTA WiFi or VISTA XLT with a Recording Group
- Appendix A: Using VISTA SmartConnect
- Appendix B: Using the QuickConnect Mobile Charger
- Appendix C: Upgrading VISTA, VISTA WiFi, and VISTA-Related Devices
- Appendix D: VISTA Transfer Station Setup
- Index
types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
l
VISTA WiFi (IC: 9073A-VST100) and VISTAXLT (IC:9073A-VST200): WatchGuard Video part number
WGP01589-200, 2.2 dbi gain, 50 Ohm impedance
l
VISTAWiFi Base (IC: 9073A-VST300): WatchGuard Video part number WGP02541, 4.5 dbi gain, 50 Ohm
impedance
Ces émetteurs radios ont été approuvés par “Industry Canada” pour fonctionner avec les types d'antennes
énumérés ci-dessous avec le gain maximal admissible et l'impédance d'antenne requise pour chaque type
d'antenne indiqué. Les types d'antennes ne figurant pas dans cette liste, ayant un gain supérieur au gain
maximum indiqué pour ce type, sont strictement interdits pour une utilisation avec cet appareil.
l
VISTA WiFi (IC: 9073A-VST100) et VISTAXLT (IC:9073A-VST200): WatchGuard Video part number
WGP01589-200, 2.2 dBi gain, 50 Ohm impedance
l
VISTAWiFi Base (IC: 9073A-VST300): WatchGuard Video part number WGP02541, 4.5 dbi gain, 50 Ohm
impedance
The antennas used for this transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Les antennes utilisées pour cet émetteur ne doivent pas être co- Les antennes utilisées pour cet émetteur ne
doivent pas être co-localisées ou fonctionner conjointement avec une autre antenne ou un autre émetteur.
This device complies with Health Canada’s Safety Code. The installer of this device should ensure that RF
radiation is not emitted in excess of the Health Canada’s requirement. Information can be obtained at
https://www.canada.ca/en/health-canada/services/environmental-workplace-
health/reports-publications/radiation/safety-code-6-health-canada-radiofrequency-
exposure-guidelines-environmental-workplace-health-health-canada.html
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le programme d’installation de cet appareil
doit s’assurer que les rayonnements RF n’est pas émis au-delà de l’exigence de Santé Canada. Les informations
peuvent être obtenues: https://www.canada.ca/en/health-canada/services/environmental-
workplace-health/reports-publications/radiation/safety-code-6-health-canada-
radiofrequency-exposure-guidelines-environmental-workplace-health-health-canada.html
CE Declaration of Conformity
In accordance with the requirements of Radio Equipment Directive 2014/53/EU, Annex III, Module B, section 3(c),
WatchGuard Video declares that the radio equipment has been designed in accordance with harmonized standards
and a full review of the equipment against the requirements of the following standards has been conducted. We
confirm that the equipment is fully within the scope of these standards.
l ETSI EN 301 489-17, V3.1.1: 2017
l ETSI EN 300 328, V2.1.1: 2016
l EN 55024:2010
l EN 55032:2012/AC:2013
l EN 62311:2008
l IEC 60950-1:2005 (Second Edition); Am1:2009 + Am2:2013
In accordance with Article 10(8) of the Radio Equipment Directive, the following information for radio equipment
with intentionally emitting radio waves is included.
VISTA XLT
Frequency band(s): Single Channel only, 2437 MHz
Maximum radiated output power: 14.7 dBm EIRP
VISTA WiFi
Frequency band(s): Single Channel only, 2437 MHz
Maximum radiated output power: 14.1 dBm EIRP
iv
VISTA Body Camera
WGD00120 Revision
ReviewDraft_070819
Draft