Product Info
Table Of Contents
- Important Notice
- Introduction
- Using the V300
- Using WatchGuard V300 Camera
- Basic workflow
- Wearing WatchGuard V300 Camera
- V300 Camera Field Of View
- Power On and Off
- Starting and Stopping a Recorded Event
- Categorizing a Recorded Event
- Momentary Muting of the Audio
- Docking the WatchGuard V300 Camera overview
- Docking the V300 Camera in a Transfer Station
- Docking and UnDocking the V300 Camera in a USB base
- Uploading events
- About the V300 Camera
- V300 Special Features
- Using V300 with a recording group
- V300 Transfer Station
- Internal Only - debug
Basic workflow
Basic workflow
The following steps make up a basic workflow for using the WatchGuard V300 Camera during
your shift:
Note: This workflow assumes the V300 battery is fully charged before the
camera is checked out to start the shift.
1. Check out V300 using Evidence Library (EL). (page 28)
2. Undock the camera.
3. Dock V300 in the WiFi base to pair it with the base and associate it with the local recording
group. (page 30)
4. Undock the camera after it has paired with the Wi-Fi base.
5. Attach the V300 securely to your clothing. (page 17)
6. Start and stop recorded events. (page 21)
7. Categorize recorded events. (page 23)
8. Power the camera off. (page 20)
9. Dock the camera to upload recorded events ((page 31)) and charge its battery (page 29).
Upload to EL.
WatchGuard V300 Wearable Camera User
Guide WGD00169 Revision A (Draft)
15