Product Info
Table Of Contents
- Important Notice
- Introduction
- Using the V300
- Using WatchGuard V300 Camera
- Basic workflow
- Wearing WatchGuard V300 Camera
- V300 Camera Field Of View
- Power On and Off
- Starting and Stopping a Recorded Event
- Categorizing a Recorded Event
- Momentary Muting of the Audio
- Docking the WatchGuard V300 Camera overview
- Docking the V300 Camera in a Transfer Station
- Docking and UnDocking the V300 Camera in a USB base
- Uploading events
- About the V300 Camera
- V300 Special Features
- Using V300 with a recording group
- V300 Transfer Station
- Internal Only - debug
Power On and Off
Use the Power button to power the WatchGuard V300 Camera on and
off. The Power button is a rectangle on the bottom of V300 Camera.
Power on
To power the camera on:
n Press and release the Power button.
The camera goes through its booting and information sequences. When it is ready to use, the
display shows the number of events in storage and displays a solid green LED light on the front.
The camera vibrates or ascending tones sound (depending on your configuration).
Tip: Press the Display Backlight button to advance through the information
sequence screens.
Power off
n Press and release the Power button.
The camera prompts you to press the Power button again.
After you press the Power button the second time, the screen shows SHUTTING DOWN and
the green LED turns off. Descending tones sound (depending on your configuration).
Note: You can configure the V300 Camera to power off automatically if it is left
idle (no movement or button presses) for a period of time. See Automatic Off,
page 57.
Forcing power off
Warning! Avoid forcing the V300 to power off. Forcing the camera to power off
can result in data corruption.
If the V300 stops responding to commands (or if WatchGuard Technical Services instructs you
to), remove the battery to force the camera to power off.
20
WatchGuard V300 Wearable Camera
User Guide WGD00169 Revision A
(Draft)