Product Info
Table Of Contents
- Important Notice
- Introduction
- Using the V300
- Using WatchGuard V300 Camera
- Basic workflow
- Wearing WatchGuard V300 Camera
- V300 Camera Field Of View
- Power On and Off
- Starting and Stopping a Recorded Event
- Categorizing a Recorded Event
- Momentary Muting of the Audio
- Docking the WatchGuard V300 Camera overview
- Docking the V300 Camera in a Transfer Station
- Docking and UnDocking the V300 Camera in a USB base
- Uploading events
- About the V300 Camera
- V300 Special Features
- Using V300 with a recording group
- V300 Transfer Station
- Internal Only - debug
USB base
USB base
Both the USB base and WiFi base have a keyed orientation so that the cameras and batteries
only dock in one direction. You can doc the battery or the camera with the battery. You can
dock the camera without the mounts attached.
When you dock the V300 in the USB base, the camera automatically starts charging, if
needed. The camera also uses the USB base to:
l Upload recorded events from storage
l Configure the camera
l Update firmware
l Define a Record-After-the-Fact
®
(RATF) event
l Request a state capture for troubleshooting
Connections
The USB base has connections for both a power cable and a USB cable (page 27).
Setting up the USB base
Caution: To prevent possible damage to some computers, connect the USB
base to the computer through the approved USB hub (Sabrent 7-Port USB
2.0 Hub, WatchGuard part number WGP02364). CHECK THIS
To set up the USB base to use with a V300 Camera and your Evidence Library software:
1. Set up the approved USB hub and connect it to the computer where your Evidence Library
software is located.
2. Plug the power cable for the USB base into an electrical outlet.
3. Connect the power cable to the USB base.
4. Connect the USB cable to the USB base and then into the approved USB hub.???
WatchGuard V300 Wearable Camera User
Guide WGD00169 Revision A (Draft)
47