Product Info
Table Of Contents
- Important Notice
- Introduction
- Using the V300
- Using WatchGuard V300 Camera
- Basic workflow
- Wearing WatchGuard V300 Camera
- V300 Camera Field Of View
- Power On and Off
- Starting and Stopping a Recorded Event
- Categorizing a Recorded Event
- Momentary Muting of the Audio
- Docking the WatchGuard V300 Camera overview
- Docking the V300 Camera in a Transfer Station
- Docking and UnDocking the V300 Camera in a USB base
- Uploading events
- About the V300 Camera
- V300 Special Features
- Using V300 with a recording group
- V300 Transfer Station
- Internal Only - debug
V300 Transfer Station
V300 Transfer Station Overview
The V300 Transfer Station is a pass-though USB to Ethernet solution. The Ethernet
throughput rate is 1-10 Gb. The transfer station supports simultaneous upload from eight
V300 Cameras to the cloud and on premise storage. While uploading events, the transfer
station can charge up to eight cameras.
When you set up the transfer station, you connect it to power and to the network containing
the Evidence Library (EL) software.
Important! To use the V300 Transfer Station to upload events, your Evidence
Library software must be EvidenceLibrary.com (EL) or Evidence Library On
Premise
When the transfer station is on, the power LED is on. The graphic shows the LEDs on the front
of the transfer station.
To set up the V300 Transfer Station:
1. Set up the V300 Transfer Station hardware. ((page 70))
2. Configure the V300 Transfer Station so the V300 Cameras docked in it will upload to your EL
software. (page 1)
Important! WatchGuard recommends that you be an IT administrator or have
your IT administrator on-call to setup the Transfer Station.
68
WatchGuard V300 Wearable Camera
User Guide WGD00169 Revision A
(Draft)