Product Info
Table Of Contents
- Important Notice
- Introduction
- Using the V300
- Using WatchGuard V300 Camera
- Basic workflow
- Wearing WatchGuard V300 Camera
- V300 Camera Field Of View
- Power On and Off
- Starting and Stopping a Recorded Event
- Categorizing a Recorded Event
- Momentary Muting of the Audio
- Docking the WatchGuard V300 Camera overview
- Docking the V300 Camera in a Transfer Station
- Docking and UnDocking the V300 Camera in a USB base
- Uploading events
- About the V300 Camera
- V300 Special Features
- Using V300 with a recording group
- V300 Transfer Station
- Internal Only - debug
Set up the hardware
Important! Enter the Station ID and Location that you entered when you
configured the V300 Transfer Station for use with your Evidence Library
software. The Station ID combined with the Location indicates a specific
Transfer Station to Evidence Library.
2. Connect the Ethernet cable to the Ethernet connector on the back of the Transfer Station.
3. Connect the power cable to the power connector on the bottom of the V300 Transfer Station
and plug the power cable into an electrical outlet
4. Power the transfer station ON using the switch on the back. The serial number is on the
bottom.
5. Connect the other end of the Ethernet cable to a computer that you have set up to access the
V300 Transfer Station factory default configuration web page.
Tip: Use the V300 Transfer Station factory default IP address to access
the default configuration web page: https://192.168.2.20. The
computer you use must have access to this network.
To continue setting up the V300 Transfer Station, follow the instructions (page 26) to
configure the V300 Transfer Station to work with your Evidence Library software.
WatchGuard V300 Wearable Camera User
Guide WGD00169 Revision A (Draft)
71