Hardware Guide

Hardware Description
Bottom Panel Connections
2.4/5GHz
Antenna connectors for the dual band Wi-Fi radios.
2.4/5GHz Scan
Antenna connector for the dual band security scanning radio.
LAN 1 (POE+)
The LAN 1 port is a 5 GbE port that connects the access point to a wired LAN connection through a
switch or hub. This port also provides PoE+ (802.3at) power for the access point.
LAN 2
The LAN 2 port is a 1 GbE LAN port that you can use as a wired extension for an SSID or for link
aggregation.
Reset Button
The reset button is located above the LAN 2 port. You must remove the weatherproof connector to
access the LAN2 port and the reset button.
To reset the access point to factory-default settings:
n Remove the weatherproof connector from the LAN 2 port.
n Use a paper clip or other small object to press the reset button above the LAN 2 port.
n Press and hold the reset button for up to 10 seconds. When you release the reset button, all LEDs
will go off to indicate that the access point has rebooted.
WatchGuard AP430CR Hardware Guide
9 WatchGuard Technologies, Inc.