Manual

• Find the serial number on your device and record it.

• Go to http://www.watchguard.com/activate

• Log in.

NOTE: If you are new to WatchGuard, follow the instructions to create a prole.

• Follow the instructions on the screen.

• It is a good idea to download and extract your WatchGuard SSL

feature key during activation. Extract the feature key on to the

computer you will use to congure your WatchGuard SSL 100.

Connect your WatchGuard SSL 100

• Make sure your computer is congured with a static IP address on the

192.168.111.0/24 network.

NOTE: The default IP address on the WatchGuard SSL 100 is 192.168.111.1.

• Connect the Ethernet interface on your computer to Eth1 on your WatchGuard SSL

device.

Getting Started

• Power on the WatchGuard SSL 100.

Run the Quick Setup Wizard

• Open a web browser and type: https://192.168.111.1:8443. Follow the directions in the

wizard to set up your WatchGuard SSL device.

NOTE: Because the WatchGuard SSL 100 uses a self-signed certicate, you may see a certicate warning in

your browser. It is safe to ignore the warning (Internet Explorer) or to add a certicate exception (Mozilla

Firefox).

• In the wizard, you must decide on the conguration mode that bests suits your

network. These diagrams show the two conguration modes:

Eth 1

green

Single

Interface

Mode

Dual

Interface

Mode

Firewall

DMZ 1

DMZ 2

Eth 0

Eth 1

switchswitch

Trusted Resources

WatchGuard SSL 100

Firewall

DMZ 1

Eth 0

switch

WatchGuard SSL 100

Trusted Resources