User manual

12
3. Operation
3.0. Turning the system on
The system is automatically turned on when the power plug is connected and
switched on. On power up the system is in the armed state, which means that
the alarm can be triggered by the detectors. This function is to make sure that
if the power is disconnected i.e. via a blackout or switched on/off that the
system is not disarmed when power is restored.
3.1. Remote Control Functions
Press
ARM/DISARM
Pressing the button will arm or disarm the alarm system
depending on the current state of the alarm. That means if
the alarm is armed then pressing the button would disarm
it, similarly if the alarm is disarmed then pressing the button
would arm it.
PANIC mode
Press and hold (approximately 3 seconds) to activate PANIC mode.
3.2. ARM Mode
When to use
This mode is used when leaving the building or premise. Arming the system in
this mode will activate all detectors.
Indications
The siren will beep once and the blue light will flash once. There will be a 20
second delay before the system is fully armed. During this delay detectors
cannot trigger the alarm.
Triggering
If a detector is triggered, when the system is fully armed, the alarm will sound
for 5 minutes or until the system is disarmed (which ever occurs first).


