User manual

16
4. Programming
Turning the unit off and on enters programming mode. On each instance of
programming mode only a single device may be learnt in. To learn in another
device programming mode must be re-entered by turning the device off then
on again.
4.1. Adding New Remotes
+
TO ADD A NEW REMOTE
1.
Turn the system off, by turning off the power supply.
Wait 10 seconds.
2.
Turn the system on.
3.
Press the remote button several times until the siren
starts beeping.
Your Watchguard Sentinel Home alarm System can only store a maximum of
FIVE wireless devices in its memory. If you learn in an 6th remote, the 1st
remote control will be erased. If you loose a remote control, or have one
stolen, or wish to delete a detector simply repeat the procedure above with
one of your remote controls at least 5 times. This will ensure that you have
erased all wireless devices (except the remote control being used in the
procedure) from the memory of your Watchguard Sentinel Home Alarm
System.