Use and Care Manual

TECHNICAL DATA
WAT-21
WATCO
®
TEAL OIL + STAIN
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙901∙0411
www.rustoleum.com
Form: ARJ-1997
Rev.: 060420
PHYSICAL PROPERTIES
TEAK OIL + STAIN
Resin Type
Raw Linseed Oil and Hydrocarbon Resin
Pigment Type
Inorganic
Solvents
Mineral Spirits, Light Aromatic Naphtha
Weight
Per Gallon
7.60-8.05 lbs.
Per Liter
0.91-0.96 kg
Solids
By Weight
62-63%
By Volume
55-57%
Volatile Organic Compounds
<350 g/l (2.87 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-1.5 mils
(25-37.5µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
160-190 sq.ft./quart. (4.0-4.6 m
2
/l)
Varies with type and porosity of wood
Dry Times at 77°F
(25°C) and 50%
Relative Humidity
Penetrate
30 minutes
Reapply
15 minutes
Light Use
8-10 hours
Topcoat
If polyurethane is desired, wait 72 hours
Shelf Life
3 years
Flash Point
104°F (40°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.