Specification
TECHNICAL DATA
WAT-02
WATCO
®
DANISH OIL
Form: RAC-05
Rev.: 012513
1
.DESCRIPTION AND USES .
Watco
®
Danish Oil is a unique blend of penetrating oil & varnish,
which hardens in the wood, not on the wood. Watco Danish Oil
penetrates deep into wood pores to protect from within and to
enhance the natural look and feel of the wood. It creates the rich,
warm glow of a traditional hand-rubbed finish. Many projects can
be completed in less than an hour - simply brush or wipe on and
wipe off.
.PRODUCTS .
Gallon Quart Pint Description
65131 65141 6515H Golden Oak
65231 65241 65251 Cherry
65331 65341 65351 Black Walnut
65431 65441 65451H Fruit Wood
65531 65541 65551 Light Walnut
--------- 214380 214381 Red Mahogany
65731 A65741 65751 Natural
65831 A65841 65851 Dark Walnut
65931 A65941 65951 Medium Walnut
PRODUCT APPLICATION .
SURFACE PREPARATION
Remove any existing finishes with sandpaper or stripper.
Prepare bare wood for staining by sanding in the direction of
the grain. Begin with #120 grit sandpaper and progress though
#150, #180 and #220 grits. Before staining, remove all sanding
dust and dirt with a vacuum, tack cloth, or rag dampened with
mineral spirits. For grease and glue, remove with a rag
dampened with mineral spirits.
WARNING! If you scrape, sand or remove old paint, you may
Release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
PRODUCT APPLICATION (cont.) .
TESTING COLOR
Be sure to test your stain to verify the desired color. To test, apply
the stain in an inconspicuous area.
OPTIONAL STEPS
Pre-treat soft woods, such as pine, by lightly wiping the wood
surface with a cloth moistened with Watco Danish Oil Natural
finish. Immediately wipe the surface completely dry and proceed
with application.
APPLICATION
Use only when air (ambient) temperature is between 60-90°F
(16-32°C) and relative humidity is below 85%. Allow for longer
dry times during damp and humid conditions. Mix or shake
material thoroughly to ensure that any settled pigment is re-
dispersed before application. Stir occasionally during use. Apply
a test sample on a small inconspicuous area before proceeding
with the entire job. Apply one coat of stain liberally with a brush or
clean lint free rag. Allow to penetrate for 5-10 minutes then
remove excess by wiping with a rag in the direction of the grain.
Removal of all excess material is essential to ensure proper dry
time and proper adhesion of topcoat.
PROTECTING THE WOOD
To complete your wood project and for the best protection finish
with any Rust-Oleum
®
Polyurethane depending on your project
needs. Polyurethane can be applied after 72 hours of applying
the stain. Darker colors may require a slightly longer dry time.
MAINTENANCE
Apply fresh coats as needed to repair surface scratches and
remove minor stains. Burnish affected area with fine steel wool or
#220-grit sandpaper, then apply the Watco Danish Oil color
originally used to finish the wood.
CLEAN UP
Application tools or brushes should be cleaned with mineral
spirits or paint thinner.