P-Trap Installation

MODEL: PS-0001
1. Apply Teflon tape to thread of the pipe (2) and screw it with the stop valve
(3).
2. Slide the escutcheon (1) onto the pipe and apply the Teflon tape to thread.
3. Screw stop valve to main water supply on wall. Use wrench to turn the valve
and let the outlet go up. (Don’t over turn the stop valve, it may damage the
valve or pipe.)
4. Close the stop valve and briefly turn on the main water supply to check for
leaks.
5. Loosen the nut (5) and compression ring (4) from stop valve, take the supply
t
ube (6) and measure the length from stop valve to faucet valve, if
necessary to cut the extra length of tube.
6. Slide the nut (7) onto the supply tube and set the cone washer (8) at top.
7. Slide the nut (5) and compression ring (4) from boom of supply tube.
8. Aach the supply tube with faucet valve and stop valve. Tighten both nuts
with wrench. (This copper supply tube can be bent slightly for installao
n )
9. Close the faucet valve and turn on the stop valve to check for leaks.
STOP VALVE AND SUPPLY TUBE INSTALLATION
○
1
○
2
○
3
○
4
○
5
○
6
○
7
○
8