P-Trap Installation

MODEL: PS-0001
P TRAP INSTALLATION GUIDE
1. Remove horizontal pipe (2) and slip joint nut (3) from bo
le trap (5).
2. Apply Teflon tape to all exposed threads.
3. Slide the slip joint nut (3) and escutcheon (1) onto horizontal pipe. Then
insert the pipe into wall waste opening.
4. Remove slip joint nut (7) and washer (6) from bo le trap, to install it onto
drain tail piece.
5. A ach bo le trap to drain tail piece and hand ghten slip joint nut.
6. Align bo le trap with horizontal pipe and drain tail piece, at this point it
may be necessary to cut part of tail piece or part of horizontal pipe to
obtain proper alignment.
7. A er all components have been properly aligned, connect the bo le trap
and horizontal pipe with slip joint nut, making sure to set the washer (4)
before
ghten the nut.
8. Check for leaks by opening faucet and le ng water run for at least one
minute.
Tail
piece
○
1
○
2
○
3
○
4
○
5
○
6
○
7