Installation Guide

MODEL: F2-0012
C) FLEXIBLE HOSE INSTALLATION
1) Install flexible hoses onto hot and cold water outlets.
2) Secure hoses with wrench. Do not over tighten.
3) Connect flexible hoses to supply tee.
4) Circle the excessive part of hoses as shown in figure below.
END BODY OUTLET
FLEX HOSE
SUPPLY TEE
SCREW
DRAIN FACE
FLANGE
ROD STRAP
SPRING CLIP
LOCK NUT
PIVOT ROD
BALL WASHER
DRAIN BODY
E) SUPPLY CONNECTION
1) Install lavatory according to manufacturer’s instructions.
2) Connect hoses (not provided) to angle stops.
3) Tighten all connections.
*** VERY IMPORTANT ***
4) Flush out water for two minutes before connect hose to faucet valve.
(This act to avoid debris trapped the flow regulator)
D) DRAIN WASTE INSTALLATION
1) Install the drain body on the shank.
2) Secure pivot rod into pivot rod opening. (on the side of drain body)
3) Adjust the position of rod strap.
4) Secure rod strap to pivot rod with spring clip.
5) Locate end of pull-up rod of spout.
6) Insert pull-up rod into rod strap.
7) Secure pull-up rod with screw.
F) INSTALLATION CHECKOUT
1) Ensure all connections are tightened properly.
2) Turn on main water supply.
3) Turn on and off cold and hot water respectively.
4) Turn on both hot and cold water and turn off. Check for leaks.
5) Remove the aerator cap and aerator. Check for debris. Clean of necessary.
6) Reinstall aerator.
COMPLETE INSTALLATION