Installation Guide

Table Of Contents

MODEL: F2-0012

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if n

ecessary

B) HANDLE VALVE INSTALLATION

1) Connect the longer flex hose to valve body.

2) Place lower plastic washer and lock nut over valve body.

3) Insert valve body from under the sink.

4) Place upper rubber washers and escutcheon on valve spindle

5) Adjust position of valve body and secure with lock nut and escutcheon.

6) Place handle on spindle and tighten with screw.

TOOLS AND MATERIALS

LAVATORY FAUCET INSTALLATION GUIDE

Basin Wrench

Adjustable wrench

Teflon Tape

Pipe Wrench

Screwdriver

Flexible Water

Supply Line

A) SPOUT INSTALLATION

1) Remove lock nut and connect tee.

2) Apply plumbers’ putty or sealant.

3) Locate mounting hole and insert spout into deck or lavatory.

4) Screw and tighten washers, lock nut onto the shank and secure the spout.

5) Screw and tighten the connect tee to the shank.

6) Remove excessive plumbers’ putty or sealant

***Half turn loosen the tee for ideal position to connect with hoses***

METAL WASHER

RUBBER WASHER

LOCK NUT

CONNECT TEE

RUBBER WASHER

PLASTIC WASHER

LOCK NUT

PAGE 1
MODEL: F2-0012 TOOLS AND MATERIALS LAVATORY FAUCET INSTALLATION GUIDE Basin Wrench Adjustable wrench Teflon Tape BEFORE YOU BEGIN 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage. 3) Replace waste or supply tubing if necessary A) SPOUT INSTALLATION 1) Remove lock nut and connect tee. 2) Apply plumbers’ putty or sealant. 3) Locate mounting hole and insert spout into deck or lavatory. 4) Screw and tighten washers, lock nut onto the shank and secure the spout.
PAGE 2
MODEL: F2-0012 C) FLEXIBLE HOSE INSTALLATION 1) Connect flexible hoses to supply tee. 2) Secure hoses with wrench. Do not over tighten. . 3) Circle the excessive part of hoses as shown in figure below. E) SUPPLY CONNECTION 1) Install lavatory according to manufacturer’s instructions. 2) Connect hoses (not provided) to angle stops. 3) Tighten all connections. *** VERY IMPORTANT *** 4) Flush out water for two minutes before connect hose to faucet valve.