F4 0001 IG

Table Of Contents

MODEL: F4-0001

A) VALVE BODY INSTALLATION

1) Prepare for installation by installing a wood crossmenber between two studs

where the valve will mount.

Important : Take into consideration the thickness of your finished wall.

If your valve is installed too far behind your finished wall, you may

be left with insufficient clearance to attach the spout and handles.

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if nec

sary

2) Mount the rough-in valve into its prepared location. Attach the valve body to

the crossmember by using galvanized pipe clamps (not included). Use a level

to ensure the valve is mounted straight.

3) Attach the main water lines to the valve. Apply thread sealant or Teflon

tape to the threaded connection to ensure a watertight seal.

WALL MOUNT FAUCET INSTALLATION GUIDE

1/2-14 NPS

WALL THICKNESS

MAX. 7/8” (22mm)

1-5/8” (42mm)

STUD

GALVANIZED PIPE CLAMP

CROSSMEMBER

(to be installed by installer)

Recommended Tools:

- Drill

- Hack Saw

- Level

- Tape Measure

- Safety Glasses

PAGE 1
MODEL: F4-0001 Recommended Tools: - Drill - Hack Saw - Level - Tape Measure - Safety Glasses WALL MOUNT FAUCET INSTALLATION GUIDE BEFORE YOU BEGIN 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage. 3) Replace waste or supply tubing if necessary A) VALVE BODY INSTALLATION 1) Prepare for installation by installing a wood crossmenber between two studs where the valve will mount. Important : Take into consideration the thickness of your finished wall.
PAGE 2
MODEL: F4-0001 4) Drill holes size as below for valve body on the finished wall. 4” (102mm) 4” (102mm) 1-1/4” (32mm), MAX 1-3/4” (45mm) B) SPOUT AND HANDLES INSTALLATION 1) Once your finished wall has been completed, slide the decorative ring onto the base of the spout. Attach the spout to the installed valve body. Once in place, tighten the set screw underneath to secure. 2) Thread escutcheons onto the stem until hand-tight. Ensure the rubber washers remain seated on the escutcheons.