Installation Guide

Table Of Contents

MODEL: F5-0010

A) FAUCET INSTALLATION

1) Set the faucet in place, insert the inlet shanks through the sink holes

and press down.

2) Assemble the washers and locknuts on the inlet shanks, then tighten the

lock nut with wrench. Do not over tighten.

3) Set the sprayer holder in place, insert the shank through sink hole.

4) Assemble the washer and locknut on the shank, then tighten the lock nut

with wrench. Do not over tighten.

BEFORE YOU BEGIN

1) Shut off water supply.

2) Carefully inspect waste and supply tubing for signs of damage.

3) Replace waste or supply tubing if necessary

B) SPRAYER INSTALLATION

1) Hand tighten the sprayer with hose together.

2) Insert the hose through the sprayer holder under to sink.

3) Connect the hose to faucet inlet and tighten with wrench.

Do not over tighten.

TOOLS AND MATERIALS

FAUCET INSTALLATION GUIDE

Basin Wrench

Adjustable wrench

Teflon Tape

Pipe Wrench

Screwdriver

Flexible Water

Supply Line

PAGE 1
MODEL: F5-0010 TOOLS AND MATERIALS FAUCET INSTALLATION GUIDE Basin Wrench Adjustable wrench Teflon Tape BEFORE YOU BEGIN 1) Shut off water supply. 2) Carefully inspect waste and supply tubing for signs of damage. 3) Replace waste or supply tubing if necessary A) FAUCET INSTALLATION 1) Set the faucet in place, insert the inlet shanks through the sink holes and press down. 2) Assemble the washers and locknuts on the inlet shanks, then tighten the lock nut with wrench. Do not over tighten.
PAGE 2
MODEL: F5-0010 C) SUPPLY CONNECTION 1) Connect hoses (not included) to angle stops. 2) Tighten all connections. 3) Flush out water for two minutes before connect hose to faucet shank D) FINAL INSPECTION 1) Ensure all connections are tightened properly. 2) Turn on main water supply. 3) Turn on and off cold and hot water respectively. 4) Turn on both hot and cold water and turn off. Check for leaks. 5) Remove the aerator cap and aerator. Check for debris. Clean if necessary . 6) Reinstall aerator.