Installation Instruction

MODEL: F2-0009
BEFORE YOU BEGIN
1) Shut off water supply.
2) Carefully inspect waste and supply tubing for signs of damage.
3) Replace waste or supply tubing if n
ecessary
B) HANDLE VALVE INSTALLATION
1) Place lower plastic washer and lock nut over valve body.
2) Insert valve body from under the sink.
3) Place upper rubber washers and escutcheon on valve spindle.
4) Adjust position of valve body. Secure valve body with lock nut and escutcheon.
5) Place handle onto spindle.
6) Tighten handle
with screw.
TOOLS AND MATERIALS
LAVATORY FAUCET INSTALLATION GUIDE
Basin Wrench
Adjustable wrench
Teflon Tape
Pipe Wrench
Screwdriver
Flexible Water
Supply Line
HANDLE
ESCUTCHEON
RUBBER WASHER
PLASTIC WASHER
LOCK NUT
VALVE BODY
METAL WASHER
LOCK NUT
CONNECT TEE
A) SPOUT INSTALLATION
1) Remove washer, lock nut and connect tee.
2) Apply plumbers’ putty or sealant.
3) Locate mounting hole and insert spout into deck or lavatory.
4) Screw and tighten washers, lock nut onto the shank and secure the spout
5) Insert pop-up rod into the spout.
6) Screw and tighten the connect tee to the shank.
7) Remove excessive plumbers’ putty or sealant
.