Installation Guide

MODEL: SL-0001
Screwdriver
Adjustable Wrench Teflon Tape
A. Set adapter (1), washer (2) and locknut (3) through the tub with coupler.
(Note: These parts are faucet water inlets, not include with this supply kit )
B. Take the supply tube (5) and put washer (4) onto the upper end of the tube.
C. Slide the decorave nut (6) up to the top of the supply tube and over the
washer.
D. Slide the escutcheon (7) up the tube slightly, then, directly under the
escutcheon, slide the locknut (8) up to the end of the tube.
E. Take the washer (9) and put it, with the wide end of the washer upward,
onto the boom end of tube.
F. Take the supply tube and aach the boom end of it to the water supply
tubing in your floor by screwing the locknut down ghtly. Set the
escutcheon to the floor.
G. Take the upper end of the supply tube and aach it to adapter. Tighten
the decorave locknut.
Note:
Use Teflon tape on all threaded connecons
Measure twice cut once.
WATER SUPPLY LINE INSTALLATION GUIDE
***WARNING***
DO NOT BEND BRASS TUBES
The faucet holes and
water main must be lined up
correctly. Attempting to
install by bending the tubes
may cause crack or leaks