Owner`s manual

For 3/8" OD tubing, use the side of
the bracket with the projections.
Valve Handle Stem
Nut/Seal
Insert
Plastic Sleeve
Compression Nut
1/4" Orange Feedwater Tubing
Piercing Lance
For 7/16" to 1/2" OD tubing or rigid pipe,
use the "V" side of the bracket.
7
Figure 3
Figure 4
1
Push in grey collet to release tubing.
2
Tubing is secured in.
Grey Collet
Tube
O-Ring
Push tubing straight in as far as it will go.
1
Pull tubing straight out.
2
To Attach Tubing To Release Tubing
This product is outfitted with user friendly ‘Push In’ connectors. Proper use of the connectors
is shown in the diagrams.
It is most important that the tubing selected for use with these connectors be of high quality,
exact size and roundness, and with no surface nicks or scratches. If it is necessary to cut the tub-
ing, use a plastic tubing cutter or sharp razor knife. Make a clean square cut.
Should a leak occur at a ‘Push-In’ connector, the cause is usually defective tubing.
To Fix: •
Relieve pressure
• Release tubing
• Cut off at least 1/4” from end.
• Reattach tubing
• Confirm connection is leak free.
‘Push-In’ Tubing Connector