Owner`s manual

SECTION 11. TESTING FOR NETWORK COVERAGE

Check the Coverage Map

CAT can provide a printed or electronic copy of the Reflex coverage map in

your state. Please contact the POOLCOMM Program Administrator.

Check the Web Site

Visit the Sky-Tel web site and enter the exact address of the facility to be

monitored. The web site will pin point that address on a custom coverage map.

Start by entering www.skytel.com into your web browser. Next select

Telemetry then Coverage and enter the address to check, select locate. The CAT

400 requires full service (Shown as Yellow) to send and receive data.

Direct Link= www.skytel.com/coverage/telemetry_coverage.htm

Test with a Portable Reflex Device

The Reflex network can be tested with any number of portable 2-way messaging

devices, such as: Skywriter, Blackberry, or and 2-way pager. To learn more or

to purchase one of these devices visit www.skytel.com. Portable 2-way devices

operate at about half the broadcast power output of the CAT 4000. Therefore, if

you portable device has full service the CAT 4000 will definitely work well in

that location. However, the CAT 4000 will communicate in locations a portable

does not.

Test w/ a CAT 4000

The best way to check for Reflex coverage at a facility is to test with an actual

CAT 4000. The Transmit data button has been provided specifically for this

purpose. Place the CAT 4000 unit where you expect to install it and press the

transmit data button. Within 2 minutes a service request alarm will be generated.

This alarm will show up at the POOLCOMM web site, and can also be directed

to your cell phone or portable 2-way device. Make sure your email address has

been entered under Notifications and that address box is checked on the unit

management page.

Secondary Carrier

If you find your client location does not have Skytel coverage contact the

POOLCOMM Program Manager for secondary carrier availability.