Owner`s manual

9. Connect the pH, ORP and Flow sensor cables to the controller unit as labeled.

Sensor cables are constructed from a specialized material - never cut or splice.

10. If new or additional chemical feeders are to be used with the controller, install

according to manufacturers instructions at this time.

11. Connect chemical feeders to the controller as labeled.

12. Check all electrical and mechanical connections. Resume filtration system

operation and check for any leaks.

Prepare Tubing:

Cut tubing squarely

and remove any

burrs. Mark tubing

3/4" from end. This

is the insertion mark.

Insert Tubing

Insert tubing straight

into fitting until it

bottoms out and

insertion mark is no

longer visible.

To Release Tubing:

Push collet toward

fitting body and pull

on tubing to release.

Repeat steps 1 and 2

to reuse fitting.

BODY

COLLET

TUBING

O-RING

WORKING WITH TRU-SEAL FLUID CONNECTIONS FOR A FAST, PROFESSIONAL INSTALLATION

INFLUENT

SAMPLE

STREAM

ORP

FEED

EFFLUENT

POWER

CORD

FEED