INSTRUCTION MANUAL CAST IRON SUMP PUMP WSSPC5V – 1/2 HP WARRANTY: PRODUCT DEFECTS COVERED 1 YEAR FROM DATE OF PURCHASE. RECEIPT AND PRODUCT DATE CODE REQUIRED FOR WARRANTY CLAIM. This pump is controlled by the attached float switch. The proper application is for use as a sump pump in a basement. By using in a sump pit, the rising water will activate the float switch, turning the pump on. Questions? Problems? Missing parts? Please call our pump experts before returning to the store! 1-800-346-7611, 8 a.m.
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product. If you have any questions, please call our pump experts at 1-800-346-7611, 8 a.m. – 4:30 p.m. EST, Monday-Friday. CHECKLIST BEFORE INSTALLATION: 1. 2. Inspect your pump. If the unit has been damaged in shipment, contact your retailer before installing. Carefully read all literature to familiarize yourself with details regarding installation and use.
Warns of hazards that CAN cause serious personal injury, death or major property damage if ignored. SEE BELOW FOR LIST OF WARNINGS 1. This pump is designed for home sump applications. 2. This pump will provide years of trouble-free service when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or blockage by ice or debris may cause the pump to fail, eventually bringing about additional water damage.
GENERAL INFORMATION: 1. Water Source pumps are equipped with either a wide-angle float switch or vertical float switch. The pump will automatically turn on when the water level in the sump pit reaches the float switch "on" level and automatically turn off when the water is pumped down to the float switch "off" level. Approximate height of float switch above base of pump Float Switch Type On Level Off Level Wide-angle (tethered) 13 in. 5 in. Vertical 5 in. 1 ¼ in. 2.
INSTALLATION: NOTE BEFORE INSTALLING: If using a sump basin lid or cover, be sure to take note of the location of the holes in the lid. You will need to install your pump and piping so that it fits properly through the lid. 1. For your own safety, turn off the electrical power at the circuit breaker/fuse box to avoid any possible electrical shock hazards. 2.
TROUBLESHOOTING CHECKLIST: (CAUTION: SHUT OFF POWER TO PUMP) PROBLEMS Pump does not run and hums Pump runs but does not deliver water POSSIBLE CAUSES ● ● ● ● ● ● ● ● ● Pump runs and pumps out sump pit, but does not stop Pump runs but delivers only a small amount of water Fuse blows or circuit breaker trips when pump starts Motor runs for a short time, then stops WATER SOURCE LLC Line circuit breaker is off, or fuse is blown.
SUMP PUMP SPARE PARTS LIST: # Description Qty Repair Kit # Description Qty N/A 8 Impeller 1 9 Washer 1 10 Washer 1 Repair Kit 1 Pump casing & Motor 1 2 Pump base 1 3 Gasket 1 4 Vertical Float Switch 1 11 Nut 1 5 Cable 1 12 Handle 1 N/A 6 Cable fitting 2 13 Screw 8 N/A 7 Bracket 1 16 Cable Gland 2 N/A 14 Screw 2 17 Packing 2 N/A 15 Screw 2 18 ADAPTER 1 BUSH-125-150 19 Tether Float Switch 1 WATER SOURCE LLC WSSPC-PBG WSSPCV-RS WSSPC-IMP WSSPC-T
LIMITED WARRANTY: This product is warranted against manufacturing defects for a period of 1 year from the date of purchase. Any misuse, abuse, or modification automatically voids this warranty. Water Source LLC will repair or replace the pump if, in its sole determination, the pump failed due to defects in materials or workmanship. WARRANTY EXCLUSIONS 1.