NON-SUBMERSIBLE WATER TRANSFER PUMP MODEL #WSTSP A C B PACKAGE CONTENTS Part A B C Description Pump Suction strainer Suction hose Quantity 1 1 1 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-346-7611, 8 a.m. – 5 p.m., EST, Monday – Friday.
TABLE OF CONTENTS Specifications ................................................................................................................................... 2 Construction ..................................................................................................................................... 2 Safety Information ............................................................................................................................ 3 Performance ......................................
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING This pump is not submersible! Do not stand in water while this pump is plugged in, and do not get the motor wet as it could cause electrocution, which could lead to serious injury or death. Always make sure the pump is unplugged as soon as the water level reaches 1/8 in. At water levels less than 1/8 in.
Additional Safety Precautions 1. Know the pump applications, limitations, and potential hazards. 2. Make certain the electrical power source is adequate for the requirements of the pump. 3. ALWAYS disconnect the power to the pump and drain all water from the system before servicing. 4. Secure the pump on a solid base to prevent the pump from tipping over and possibly falling into the water. 5. Secure the discharge hose before starting the pump.
Estimated Assembly Time: 5 minutes Materials Required for Assembly (not included): Garden Hose (50 ft. max. length) Never operate this pump unless it is secured to a solid foundation. Do not suspend the pump by the discharge hose or power cord. Keep the pump suction strainer clear. Do not install pump directly on sand or dirt. INSTALLATION INSTRUCTIONS 1. Add water (approximately 1-2 Tbsp.) into inlet to wet the impeller of the pump (A). A 2.
4 4. Thread a 5/8 in. or larger garden hose (sold separately, 50 ft. max. length) onto the discharge outlet of the pump (A). A C NOTICE: Make sure the end of the outlet hose is not under water. If the outlet is under water, the pump may not work. NOTICE: Do not coil or kink the hose. 5. Attach the pump (A) to a sturdy base (table, board, etc.) to prevent it from tipping over. Make sure the hoses are as straight as possible.
TROUBLESHOOTING If the pump is not running properly, remove the 6 impeller cover screws (#1), remove the impeller cover (#2), and inspect the O-ring (#3) and impeller (#4). If there are any damages to these parts, please contact 1-800-346-7611. Note: Do not disassemble the motor housing of the pump. This pump has NO repairable internal parts, and disassembling may cause a dangerous electrical wiring conditions.
Problem Pump does not start or run Possible Cause 1. Blown fuse 2. Tripped breaker 3. Plug disconnected 4. Corroded plug 5. Motor overheated Pump doesn’t prime 1. Air leak in suction line Flow rate is too low 2. 3. 4. 1. 2. 3. 4. Impeller clogged Impeller worn or damaged Impeller dry Hose kinked or coiled Strainer or hose blocked Discharge hose too long Worn impeller Corrective Action 1. Replace fuse 2. Reset breaker 3. Secure plug 4. Clean plug prongs 5.
