Instructions / Assembly

1. Mounting the Wall Bracket
Locate your level, Measuring Tape, and Screwdriver.
a. Draw a line on the wall indicating the top of where you would like to
mount your waterfall. See Fig 1.A.
b. Using your measuring tape, measure from the top of your fountain
down to the center of your wall bracket and record your
measurement.
c. Using the measurements obtained in point ‘b’, measuring down from
the line drawn in point ‘a’, draw vertical line on the wall to indicate
the location of the wall bracket sitting position. See Fig 1.B. Using a
level, hold the Wall Bracket (I) to the wall with the top angled
towards you. Mark both mounting holes on the wall. Remember to
double-check your measurements. See Fig 1.C. & 1.D
1.B
1.C
1.D
1.E
Locate EZ Anchors (J). The number of EZ Anchors must match the
number of holes located on the Mounting Bracket.
d. To install the EZ Anchors™ (J), gently tap or press the tip into the
drywall and slowly screw the anchors into the wall. See Fig 1.E.
Make sure the flat side of the anchor is flush with the wall. Do not
over-tighten the anchors as this will render them ineffective, as well
as damage the drywall. If you encounter a wall stud while installing
an EZ Anchor™ (J), use the 1” mounting screw without the anchor.
See Fig 1.F. We only suggest using the provided EZ Anchors™ (J)
since each EZ Anchor™ (J) has a weight capacity of up to 50 pound.
Plastic anchors are not an acceptable substitute. A correctly installed
wall bracket is illustrated in Fig 1.G.
1.F 1.G
1.A