Water Wonders NSI Slate™ 1-2-3 Installation Instructions 635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721 www.bluworldusa.com · http://shop.bluworldusa.
Parts List (A) LED Light Bar (E) Pump (B) LED Transformer Wire (C) LED Remote (F) Header (G) Shroud (H) Rock Tray (J) Tap Screws and EZ Anchors™ (D) Wire Clip (I) Wall Bracket (K) Rocks Water Wonders Assembly: Tools Required: Level Pencil Phillips Screwdriver Measuring Tape Decide where you would like to install your fountain. ** It is critical that your waterfall is level as this will ensure even water flow. ** a.
1. Mounting the Wall Bracket Locate your level, Measuring Tape, and Screwdriver. a. Draw a line on the wall indicating the top of where you would like to mount your waterfall. See Fig 1.A. b. Using your measuring tape, measure from the top of your fountain down to the center of your wall bracket and record your measurement. 1.A c.
2. Installing the Waterfall a. Lift your fountain and carefully slide it onto the wall bracket making sure that the bracket on the back of your fountain is resting securely on the wall bracket. 2.A 2.B 2.D 2.C b. Locate the Header (F) and Shroud (G). Install the Shroud (G) by carefully sliding it behind the panel and down onto the reservoir as shown in Figures 2.C & 2.D. Install the Header (F) by simply sliding it into the support rails located behind the fountain as shown in Figures 2.A & 2.B. c.
c. Locate your Power Cord and plug into the transformer as shown in Fig 2.H. Unwind the cord and run it down the back of the fountain. Place the second Wire Clip (D) and stick to the center of the bracket located on your water feature and clip the Power Cord wire as noted in Figure 2.I & 2.J. 2.H 2.I 2.J d. After completely unwinding the LED Light Bar (A) and Pump power cords, lift your waterfall into place and engage the brackets by lowering it onto the Wall Bracket (I) as shown in Fig 2.K.
Warranty Bluworld’s Warranty has changed as of August 1, 2008 and supersedes all previous warranties for product purchased after August 1, 2008. If there is printed material within this shipment it is considered void and the Warranty as stated below is policy. Bluworld product is warranted against defects that render it unfit for its reasonably intended use.