Instructions / Assembly

2. Installing the Waterfall
a. Lift your fountain and carefully slide it onto the wall bracket
making sure that the bracket on the back of your fountain is
resting securely on the wall bracket.
2.A
2.D
2.B 2.C
b. Locate the Header (F) and Shroud (G). Install the Shroud (G) by
carefully sliding it behind the panel and down onto the reservoir as
shown in Figures 2.C & 2.D. Install the Header (F) by simply
sliding it into the support rails located behind the fountain as
shown in Figures 2.A & 2.B.
c. To install the LED Light Bar (A), simply place the LED Light Bar
(A) into the top of the Header (F) as shown in Figure 2.E. Then
using the other Wire Clip (D) provided, peel and stick wire clip
(D) to the inside of the Header (F) as shown in Figure 2.F & 2.G.
2.E
2.F
2.G