Instructions / Assembly

2.H 2.I 2.J
2.K
d. After completely unwinding the LED Light Bar (A) and Pump power cords, lift
your waterfall into place and engage the brackets by lowering it onto the Wall
Bracket (I) as shown in Fig 2.K. After mounting your fountain to the wall, fill
the reservoir with water (distilled water is strongly recommended).
e. The water level must be maintained at least 1/2” above the pump. If the water
level drops below the pump, damage may occur.
c. Locate your Power Cord and plug into the transformer as shown in Fig 2.H. Unwind the cord and run it down
the back of the fountain. Place the second Wire Clip (D) and stick to the center of the bracket located on your
water feature and clip the Power Cord wire as noted in Figure 2.I & 2.J.
3. Operating the Waterfall
b. Install Rock Tray (H) and spread Rocks (K) as shown in Figures 3.A - 3.C.
a. After filling the fountain with water, plug the LED Light Bar (A) pump into the wall. As water begins to
flow down the surface, guide the water with your hand or use a non-abrasive sponge until the water flows
evenly over the entire waterfall surface. It may take a few minutes for the water to cover the entire
waterfall surface.
3.A
3.B
3.C