Installation Instructions

ManualsBrandsWaterford ManualsBuilding materialsTriple 3" x 12' 1" Clay Vinyl Siding

IT DEEMS TO BE EQUIVALENT IN VALUE AND QUALITY. Any

dispute concerning this warranty shall be submitted to binding

arbitration to a mutually agreed arbitrator; or, if the parties fail to

agree, to the American Arbitration Association to be resolved using

its Commercial Arbitration Rules. The jurisdiction of the arbitrator

over the dispute shall be exclusive and the decision of the arbitrator

shall be binding on the parties and nonappealable.

6. EXCLUSION OF OTHER REMEDIES

IN NO EVENT SHALL WE BE LIABLE TO ANY PERSON FOR AN

AMOUNT GREATER THAN THE VALUE OF THE REPAIR OR

REPLACEMENT OF THE PRODUCT. IN NO EVENT WILL WE BE

LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT, MULTIPLE,

PUNITIVE OR CONSEQUENTIAL DAMAGES RESULTING FROM

ANY DEFECT IN THE PRODUCT(S) SUPPLIED, INCLUDING, BUT

NOT LIMITED TO DAMAGE TO PROPERTY OR LOST PROFITS

REGARDLESS OF WHETHER SUCH CLAIMS ARE BASED ON

THEORIES OF CONTRACT, WARRANTY, TORT (INCLUDING

NEGLIGENCE AND GROSS NEGLIGENCE), STRICT LIABILITY,

STATUTORY LIABILITY OR OTHERWISE. Some states do not allow

the exclusion or limitation of incidental or consequential damages,

so the above limitation or exclusion may not apply to you.

WARRANTY INFORMATION CAN BE FOUND ONLINE AT

WWW.ABTCO.COM

7. RESPONSIBILITY OF PURCHASER/OWNER

COMPLIANCE WITH EACH OF THE ITEMS SET OUT BELOW

IN SECTIONS A AND B INCLUSIVE IS A CONDITION TO OUR

OBLIGATIONS UNDER THIS WARRANTY AND THE FAILURE TO

COMPLY WITH ANY ONE OR MORE OF THE ITEMS SHALL VOID

ANY RIGHTS OWNER OR PURCHASER MAY HAVE UNDER THIS

WARRANTY.

A. WARRANTY REGISTRATION/CLAIMS

(i) A warranty registration card must be properly completed and

mailed to us within 30 days after the Product(s) installation date. A

card is attached for your convenience.

(ii) All claims under this Warranty must be sent in writing within 45

days after the discovery of the defect, and before beginning any

permanent repair, to us at KP Building Products, 402 Boyer Circle,

Williston, VT 05495.

B. OTHER

(i) The Owner must notify us of any change in ownership of the

home on which the Product(s) are installed within 90 days of the

transfer of title.

(ii) IT IS THE OWNER’S RESPONSIBILITY TO ESTABLISH THE

DATE OF INSTALLATION. The Owner should do this by retaining

any records which would tend to prove when the Product(s)

was installed, including but not limited to: purchase invoices

and receipts, contractor’s billings, service contracts and building

permits.

(iii) Upon reasonable notice, the Owner must allow our agents to

enter the property and building on which the Product(s) is installed

to inspect such Product(s).

THE VINYL SIDING INSTITUTE’S IMPORTANT FIRE SAFETY

INFORMATION STATEMENT IS AS FOLLOWS:

Exterior vinyl building materials require little maintenance for many

years. Nevertheless, common sense dictates that builders and

suppliers of vinyl products store, handle and install vinyl materials

in a manner that avoids damage to the product and/or structure.

Owners and Installers should take a few simple steps to protect vinyl

building materials from fire.

TO HOME AND BUILDING OWNERS:

Rigid vinyl siding is made from organic materials and will melt or

burn when exposed to a significant source of flame or heat. Building

owners, occupants and outside maintenance personnel should

always take normal precautions to keep sources of fire, such as

barbeques, and combustible materials, such as dry leaves, mulch

and trash, away from vinyl siding.

TO THE BUILDING TRADES, SPECIFIERS, PROFESSIONALS AND

DO-IT-YOURSELF INSTALLERS:

When rigid vinyl siding is exposed to significant heat or flame, the

vinyl will soften, sag, melt or burn, and may thereby expose material

underneath. Care must be exercised prior to installation when

selecting underlayment materials because many underlayment

materials are made from organic materials. All building materials

should be installed in accordance with local, state, and Federal

building codes and fire regulations.

CARE AND MAINTENANCE

While ABTCO vinyl siding remains virtually maintenance-free,

it will become dirty as any other product which is exposed to

atmospheric conditions. Normally, your ABTCO vinyl siding can be

cleaned satisfactorily through the use of an ordinary garden hose.

If stubborn stains cannot be removed with water, the following

procedure should be used:

1. Equip the garden hose with a soft-bristled, long handle car brush.

2. Where soil is of a stubborn nature, the following cleaning

solution works well:

- 1/3 cup household detergent

- 2/3 cup trisodium phosphate

- 1 gallon water

In certain geographic areas where mildew may be a problem,

substitute one quart of 5% sodium hypochloride (household

bleach) for one quart water in the above formula. Where the house

is extremely dirty, it is recommended that you start washing from

the bottom and go to the top, rinsing frequently. Cleaning solutions

should be permitted to stand on the surface of the siding for several

minutes before rinsing.

All questions concerning the meaning or applicability of this limited

warranty are to be decided under the law of the State of Oregon

without reference to its choice-of-law rules.

This Warranty gives you specific legal rights, and you may also have

other rights which vary from state to state.

For further information, contact:

KP Building Products Quality Assurance Manager

402 Boyer Circle

Williston, VT 05494

ABTCO and all other company names and product names are

trademarks or registered trademarks of KP Building Products.