TL-SF1005D TL-SF1008D TL-SF1016D 10/100Mbps Desktop Switch REV: 1.0.
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TPLINK TECHNOLOGIES CO., LTD. Copyright © 2008 TP-LINK TECHNOLOGIES CO., LTD.
CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. SAFETY NOTICES Cautions Do not use this product near water, for example, in a wet basement or near a swimming pool. Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Package Contents The following items should be found in your box: ¾ One TL-SF1005D/TL-SF1008D/TL-SF1016D Switch ¾ One Power Adapter ¾ This User Guide ) Note: Make sure that the box contains the above items. If any of the listed items are damaged or missing, please contact with your distributor.
CONTENTS Chapter 1. Introduction of the Product................................................................... 1 1.1 Overview of the Product............................................................................ 1 1.2 Convention................................................................................................ 1 1.3 Features.................................................................................................... 1 Chapter 2. Installation......................................
Chapter 1. Introduction of the Product Thank you for choosing the TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch. 1.1 Overview of the Product TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch provides 5/8/16 10/100Mbps Auto-Negotiation RJ45 ports. All ports support Auto MDI/MDIX function, eliminating the need for crossover cables or Uplink ports.
¾ Plastic case, desktop or wall-mounting design ¾ External Power Adapter supply Chapter 2. Installation 2.1 Mounting the Switch on a Desk To install the Switch, please follow the steps: 1) You can place the Switch on a flat desk. 2) Please inspect the Power Adapter carefully and make sure that it is properly connected to a power source. 3) Ensure adequate ventilation space around the switch for dissipating heat and air. ) Note: Please avoid any heavy thing placed on the switch. 2.
Chapter 3. Identifying External Components This Chapter describes the front panel, rear panel and LED indicators of the Switch. 3.1 Front Panel Figure 3-1 TL-SF1016D Switch Front Panel The Switch’s LEDs are located on the front panel. ¾ Power LED: This indicator will light up when the Switch powers on. ¾ LEDs (1-16): One LED indicator will light green when a device is connected to the corresponding port. It flashes when data is being transmitted or received on the connection. 3.
Appendix A: Specifications General Standards IEEE802.3 10Base-T, IEEE802.
Appendix B: Troubleshooting 1. The Power LED is not lit Check to see if the power cord is connected to the Switch properly, and make sure the power source is ON. 2. The Link/Act LED is not lit when a device is connected to the corresponding port Check to see if the cable connectors are firmly plugged into the Switch and the device, and verify the connected device is turned on and working well. Make sure the cable is not longer than 100 meters (328 feet).
