Specifications

IPv4 and IPv6 Internet and WAN Settings

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308

7. In the Internet (IP) Address section of the screen (see the following figure), configure the IP

address settings as described in the following table. Click the Current IP Address link to

see the assigned IP address.

Figure 17.

Other (PPPoE)

Note: For login

and password

information, see

Step 3 and Step 4.

If you have installed login software, your connection type is PPPoE. Select this radio

button, and enter the following settings:

Account Name The valid account name for the PPPoE connection.

Domain Name The name of your ISP’s domain or your domain name if your ISP

has assigned one. You can leave this field blank.

Idle Timeout Select the Keep Connected radio button to keep the connection

always on. To log out after the connection is idle for a period, select

the Idle Timeout radio button and, in the Idle Timeout field, enter the

number of minutes to wait before disconnecting. This is useful if your

ISP charges you based on the period that you have logged in.

Connection

Reset

Select the Connection Reset check box to specify a time when the

PPPoE WAN connection is reset, that is, the connection is

disconnected momentarily and then reestablished. Then specify the

disconnect time and delay.

Disconnect

Time

Specify the hour and minutes when the connection

should be disconnected.

Delay Specify the period in seconds after which the

connection should be reestablished.

Table 3. PPTP and PPPoE settings (continued)

Setting Description