Installation Sheet

EXTEND 1/4”

Slide compression nut (G)

over end of blue supply

tube (H). Slide ferrule (J)

onto end of blue supply

tube, long tapered end

rst. Push tube insert

(K) into top of blue

supply tube.

Slide ferrule until 1/4”

of tubing is showing

out the end.

Insert extended

portion of tubing and

tighten compression

nut to end of faucet

shank with wrench.

RETAINING CLIPS

CARBON FINES

AND MILKY

APPEARANCE

IN WATER

INVERT UNIT

SYSTEM ACTIVATION AND INSPECTION

Open the dispensing faucet at the sink. Next, open the

feed water valve to the system (M), then angle stop

(N). Observe all tubing and connections for several

minutes to detect any leaks. Allow the faucet to run for

at least 3 minutes, then close the faucet. During the

3-minute ush, a small amount of carbon nes may be

seen in the initial ushing of the system. This is normal.

The water also may appear to be milky. This is due to

air being trapped in system. If practical, invert the unit

until air ceases to purge from the faucet. Check ttings

again for leaks after closing the faucet. The system is

now ready for use.

Check all tubing connections to ensure

they are rmly seated. CHECK TO SEE

THAT THE CARTRIDGE RETAINER

CLIP IS PROPERLY INSTALLED WITH

THE SLIDE LOCKS FULLY ENGAGED

IN FRAME SLOTS. The retainer clip

must be in place during long term ,

unattended operation of the system.

Failure to keep the retaining clip

properly engaged could result in

accidental leaks and ooding.