BRIDGE FAUCET INSTALLATION INSTRUCTIONS 6100-12 6150-12 6100-18 6150-18 6200 6250 6300 6350 Model #s: 6100-12 6100-18 6150-12 6150-18 6200 6250 6300 6350
INSTALLATION GUIDE BEFORE YOU BEGIN YOUR INSTALLATION: 1 2 Turn off water supply. 3 Observe all local plumbing codes. 4 Inspect waste and water supplies for signs of damage. Replace as necessary. REQUIRED TOOLS: DO NOT use petroleum based products on this faucet. PARTS INCLUDED: HK-BHC BRIDGE KITCHEN FAUCET HANDLE CAP KIT 1. Adjustable Wrench 2. Phillips Screwdriver HK-USM1250 UNDER SINK MOUNTING HARDWARE KIT (1-1/4”) FAUCET HOLE PLACEMENT 1. Recommended deck hole 1-3/8”.
FAUCET INSTALLATION 1. 2. C C COUNTER OR SINK B A D B A Remove clamp nut (A) and washer (B) from threaded shroud (C). 3. D Fit flexible hoses (D) and rigid sidespray tube (E) through holes on counter or sink. (No plumbers putty is required. O-rings seals base). 4. F Slide washer and thread the clamp nut onto threaded shroud. Tighten nut snug to underside of sink or counter. E F Securely tighten clamp screws (F). CONNECTING SUPPLY HOSES 1.
OPTIONAL DECORATIVE CAPS 1. Place a small standard screwdriver in slot at bottom of metal ring that surrounds handle caps. Gently pry button from faucet handle. 2. Position cap and snap in with thumb. COMPASS HOT AND COLD CROSS HANDLE LEVER HANDLE LEVER HANDLE FINISH MATCH CONNECTING OPTIONAL SIDE SPRAY 1. 2. 3. A G 4. COUNTER OR SINK B F D C E 1. Insert side spray base (A) into side spray hole on your sink or counter. No plumbers putty is required. O-ring seals base.
CARE AND CLEANING FOR WATERSTONE FAUCET FINISHES ATTENTION: Waterstone offers many finishes for it’s faucet product line. Every finish is unique and requires different techniques of care and cleaning. Find your faucet’s finish in sections below, then carefully read and follow directions for that finish. ABOUT YOUR FINISH: These finishes have a clear protective coating on them. Even though they have a protective coating, they are only considered semi-durable.
ABOUT YOUR FINISH: Weathered Copper - WC This finish is considered a Living Finish and has NO PROTECTIVE COATING on the surface. Living finishes are finishes that have a very shallow patina on their surface. Essentially, the finish is what nature would do to the surface over a long period of time. The finishes are intended to change with time and generally darken slightly where they are not being touched, and highlight where the high use points are on the fixture.
