GANTRY PULLDOWN FAUCET INSTALLATION INSTRUCTIONS ® 3700 4400 3710-12 4410-12 Gantry Model #: 3700 3710-12 3710-18 4400 4410-12 4410-18 3710-18 4410-18
INSTALLATION GUIDE BEFORE YOU BEGIN YOUR INSTALLATION: 1 2 Turn off water supply. 3 Observe all local plumbing codes. 4 Inspect waste and water supplies for signs of damage. Replace as necessary. REQUIRED TOOLS: DO NOT use petroleum based products on this faucet. PARTS INCLUDED: *XX represents finish HK-THC-XX* TRADITIONAL HANDLE CAP KIT (TRADITIONAL ONLY) 1. Adjustable Wrench 2.
GANTRY® PULLDOWN FAUCET INSTALLATION 1. 3. 2. A COUNTER OR SINK F D B C Fit flexible hoses (B, C) through hole on counter or sink. (No plumbers putty is required. O-ring will seal base). Using scissors, cut plastic tie on hose protector tube (A) and remove. 4. E Slide washer (D) and thread the clamp nut (E) onto threaded shroud. Tighten nut snug to underside of sink or counter. Turn faucet to the desired handle position. Securely tighten clamp screws (F).
HOW TO ADJUST HANDLE POSITION AND HANDLE TENSION On some kitchen countertops, the handle may hit the backsplash when the faucet handle is positioned to the left or right (Fig. G 1). Waterstone gives you the option of adjusting the handle 45 degrees to avoid hitting backsplash. D E FIG.1 ORIGINAL FACTORY POSITION MAY HIT BACKSPLASH F NEW ADJUSTED POSITION CLEARS BACKSPLASH CONTEMPORARY B C C D 1. Unscrew and remove the metal cap (A). Remove Hot and Cold Indicator Ring (B). 2.
