Installation Guide

STEP FIVE

Look under your tub. The rails should be approximately 1/2” off the floor. The space between

the tub bottom and floor must be completely filled with mortar and the mortar covered with

plastic sheet in step six.

STEP SIX

Take the tub out of the cabinet and place enough mortar onto the floor in the area under the

bottom of the tub to completely fill the space you saw in step five. This is usually 2” to 4”.

Cover mortar with 3 to 5 mil plastic sheet to allow the tub to be removed in the future.

NOTE:

The tub’s weight (including bather

And water) must be fully supported

by the mortar under the tub’s bottom-

not the tub lip that rests on

cabinet tile.

STEP SEVEN

Place the tub back in cabinet and push downward until tub lip rests evenly on top of cabinet,

Area between the tub bottom and the floor is filled completely, and the mortar squishes out

around the tub’s bottom.

WARNING!

DO NOT GET INTO TUB FOR ANY REASON UNTIL

MORTAR BED HAS CURED COMPLETELY AS YOUR TUB

COULD BE DAMAGED AND VOID OUR WARRANTY.

QUESTIONS?

PLEASE CALL: 1-800-289-8827 FOR ASISTANCE