Installation Guide

OPERATING YOUR NEW WHIRLPOOL

Before you turn your whirlpool on it should be filled with water two

inches above the highest jet. To turn the whirlpool on press the

round ON/OFF button installed on your tub. To turn the bath off press

the button again. If the pump does not start, either the GFCI is

tripped, there is no electrical power, or the tube to the motor is

disconnected at the air switch or motor.

For tubs that do not come with installed

buttons and controls, the installer must

mount all controls above water level on

a nearby surface.

THREE SPEED CONTROL

The three speed control button allows the bather to simultaneously

switch all jets from high to medium to low instead of individually adjusting

each jet’s pressure.

ADJUSTING YOUR TUB’S JETS

Your Watertech Whirlpool Bath comes equipped with high performance

spa jets that allow the bather complete control of water pressure and

direction. Rotating the jet’s circular face to the right increases the water

pressure and volume or to the left reduces the pressure and volume.

The direction of the water flow may be changed by moving the jet

eyeball up, down, left, or right to direct the water to the desired location.

JET CLEANING OR SERVICING

Each jet face is easily removed

from the inside of the tub for service

or cleaning. The jet face and the

pulsating face may be removed by

carefully prying away from the tub

with a thin spatula or putty knife.

Care should be taken not to

scratch the tub or jet. To avoid causing

leaks do not disturb the inner retainer.

OPTIONAL LOW WATER SENSOR CONTROL UNIT

The optional factory installed low water sensor

protects your whirlpool from running if there is

not enough water to operate safely. Should

your whirlpool fail to operate when filled to the proper depth be sure there is

electrical power available at the outlet. If power is available adjust the sensor by

filling your tub to the proper depth. Locate the sensor under your tub and slowly

turn the sensor adjustment screw until the indicator light turns on. Back the

screw slowly until the light goes off. Very slowly turn the screw until the light just

comes on again. Drain the tub water below the water level sensor. The light should