Instruction Manual

ManualsBrandsWaterworks ManualsAccessories for videoSentinel II Ceiling Mounted Round Lighting

Sentinel II

Sconce

1/08

WATERWORKS

Installation Guidelines

®Refer to the specification and assembly drawings attached.

This product is sold partially assembled but shown fully

disassembled for illustrative and service purposes only.

®Inspect this product to assure you have all parts required

for proper installation.

®Use only a strap wrench or protected/smooth-jaw

wrench on any finished surface.

®Light can be wall or ceiling mounted.

INSTALLATION:

IMPORTANT: Light weighs 15 lbs. Junction box (7) NOT

provided must be secured to adequate blocking or stud

material.

1. Determine the orientation of the light and install either a

2" x 4" rectangular (wall mount) or 4" octagonal (ceiling

mount) junction box.

2. Run 120vac, 60hz electrical service to the junction box.

Install and Ground per NEC and local codes.

3. Unthread the 2 knurled fixture cover screws (1) and lift

off the fixture cover (2).

4. Connect fixture wires(6) to the house wires, note green

fixture wire is ground.

5. Secure fixture (4) to junction box using the following

junction box screws(3) NOT provided:

2" x 4" rectangular: 2 - #6-32

4" octagonal: 2 - #8-32

6. Verify the fixture is level before continuing.

7. Install (2) 7 watt max., E12 candelabra base ballasted

flourescent bulb; max length is approx. 4

" (5).

8. Reinstall fixture cover and hand-tighten the fixture cover

screws.

®If further assistance is required, please contact Product

Support at 1-800-927-2120 (8am-7pm EST).

WWLT72

5 X2

IMPORTANT:

To ensure this product is installed properly, you must read

and follow these guidelines.

The owner/user of this product must keep this information

for future reference.

WARNING: The power supply must be turned off prior

to installation.

®Be sure your installation conforms to all applicable codes.

These guidelines have been prepared for the professional contractor to aid in the installation of:

SENTINEL II SCONCE (WWLT72)

All dimensions are based on original specifications and are subject to change and variation.

Please consult your Design Associate for current specifications.

Summary of content (3 pages)

PAGE 1
Installation Guidelines Sentinel II ® Sconce WWLT72 ®Refer to the specification and assembly drawings attached. This product is sold partially assembled but shown fully disassembled for illustrative and service purposes only. ®Inspect this product to assure you have all parts required for proper installation. 121/4" ®Use only a strap wrench or protected/smooth-jaw wrench on any finished surface. 3/4" ®Light can be wall or ceiling mounted. INSTALLATION: IMPORTANT: Light weighs 15 lbs.
PAGE 2
Care and Cleaning The lustrous finish on your fitting or fixture should be treated with care. To clean the finish, wipe gently with a soft damp cloth and then with a soft dry towel. A mild soap solution can be used for daily cleaning. The use of non-recommended polishes, abrasive cleaners, solvents,ammonia-basedproducts, or acid-based cleaners may damage the finish. Please know that improper handling or cleaning may damage the surface of the finish and consequently void the warranty.
PAGE 3
Warranty Waterworks warrants to the initial purchaser or initial homeowner all plumbing* and accessory** products sold by Waterworks, which are installed in a residence to be used in a residential application, to be free from manufacturing defects in materials and workmanship for as long as the purchaser continues to own and maintain the residence where the products are initially installed. Proof of purchase (original sales receipt) from the original consumer purchaser must accompany all warranty claims.