Warranty
Proper Hose Set Up
• To ensure maximum flexibility, set up should be
performed in temperatures above 70 degrees.
• Remove all packaging and ties.
• Check that the washer is properly seated in the
coupling that attaches to the home/spigot.
• Unwind the hose loosely in a circular motion before
attaching to the spigot or faucet.
• Run water through the hose.
• Leave the hose laid out straight and allow it to heat
up during the day.
• Wind hose accordingly.
Care for your hose
• Disconnect and reconnect the hose from any standard metal faucet/hose bib and/or
metal hose attachment a minimum of 2 times per year to maintain a proper seal of
the washer. Loosen any possible corrosion evident caused by weather or
environmental elements which can cause the hose to fuse to the faucet or
attachment.
• Always inspect the washer for proper placement and clear any build-up on the
faucet, coupling or washer. This will help prevent potential leaks.
Storage Instructions
• Drain your hose when you are not using it.
Water left in a hose for extended periods of time
may result in the formation of bacteria.
• Store this hose indoors when not in use.
WARNINGS
• Do not run hot water through this hose.
• Do not leave the hose under pressure when it is not
in use. Heat or pressure may damage your hose, and
could cause it to leak or burst.
• Not intended for indoor use.
Warranty
Swan Products, LLC® warrants this hose against defects
in workmanship or materials under normal use for the
“Warranty Period”. If a defect arises and a valid claim is
received within the Warranty Period, Swan Products, LLC®
will exchange the defective product for a new one of
equal or better quality.