User`s manual

4.2 WATLOW Series 982 User’s Manual
Setup Menus, Chapter 4
Figure 4.2 -
The Input Menu.
Setup-Input
❸ Select the Input Menu, then
press the Mode key µ to step
through the prompts.
TL
W
W
A
PROCESS
L1 L2 L3 L4
DEV
% OUT
DISPLAY
SERIES 982
MODE
HOLD
RUN
❹ Press the Up-arrow key > or
the Down-arrow key < to select
one of the prompt values.
…
…
…
*Prompts may not appear, depending
on controller configuration.
Reaching the Input Menu
→ [InPt] Input Menu
↑ µ
[`SEt] Setup Menus
↓
?
µ
[`In1] Input 1 (page 4.3)
↓ ?
µ
[dEC1] *Decimal 1
↓ ?
µ
[`rL1] Range Low 1
↓ ?
µ
[`rH1] Range High 1
↓ ?
µ
[CAL1] Calibration Offset 1
↓ ?
µ
[rtd1] *RTD Calibration Curve 1
↓ ?
µ
[Ftr1] Input 1 Software Filter
↓
?
µ
[`In2] *Input 2 (page 4.8)
↓ ?
µ
[`rL2] *Range Low 2
↓ ?
µ
[`rH2] *Range High 2
↓ ?
µ
[LrnL] *Learn Low
↓ ?
µ
[LrnH] *Learn High
↓ ?
µ
[CAL2] *Calibration Offset 2
↓ ?
µ
[Hunt] *Hunt (page 4.11)
↑
↓
?
←µ [SHYS] *Slidewire Hysteresis
Enter your settings,
from the controller’s
upper display.