Owner manual

Appendix A: Ramp Soak
CLS User’s Guide 123
Editing the Ready Setpoint
When you assign a profile to a loop, the profile doesn’t start
immediately; instead, it goes to the ready segment (segment 0) and stays
there until you put the profile in Start mode.
You can set a setpoint, assign events, and set event states for the ready
segment. Use this menu to set the ready segment setpoint.
Selectable Values:
-999 to 9999, or Off.
Editing the Ready Event States
Use this menu to set the ready state for all outputs that are not used for
control or for the SDAC clock. When you assign a profile, the controller
starts the ready segment: it goes to the ready setpoint and puts all the
outputs in the ready state you set here. The outputs stay in the ready
state until the end of segment 1, when segment 1’s events become
active.
When you press NO, you will advance to the next menu. If you press
YES, this menu appears:
Selectable Values:
You can toggle inputs that are not IN USE to On or
Off.
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
A READY SEGMENT
SETPOINT ? OFF
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
B READY SEGMENT
EDIT EVENTS?
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
READY EVENT
OUTPUT 15? OFF