Owner manual

18 CLS User’s Guide
Installation
TB-50 Mounting Instructions
These steps tell you how to mount the TB-50. (Please follow these steps
exactly, so you don’t damage the terminal block, the ribbon cable, or the
controller.)
1. Choose a mounting location. Be sure there is enough clearance to
install and remove the TB-50; it measures 3.4" long X 3.2" wide X
1.27" tall.
2. Watlow Anafaze shipped the TB-50 to you in an antistatic bag.
Make sure these parts are also in the bag:
•
Five plastic standoffs.
•
Five 6-32 screws.
•
Five cable tie wraps.
•
One 50-pin ribbon cable.
•
Five ribbon cable clamps.
3. Snap four of the plastic standoffs into the four mounting holes on
the TB-50.
There are also four smaller holes on the terminal board, as shown
here. These holes are for the cable tie wraps--the plastic standoffs
won’t fit them. You’ll use these holes to secure wiring to the termi-
nal block. (See
Wiring Outputs
in this chapter for help installing
cable tie wraps.)
1
12345678910111213A
25242322212019181716151413B
262728
29
3031
3233
34
35
36
3738A
504948474645
4443424140
3938B
B
B
B
B
A
A
A
A
Holes labeled "A"are m ounting holes.
Holes labeled "B"aretiewrap holes.