Owner manual

Installation
CLS User’s Guide 19
4. Place the TB-50 where you will mount it and use a pencil to trace
around the standoffs.
5. Drill and tap #6-32 holes in the locations you marked.
6. Place the TB-50 where you will mount it. Insert the #6 screws in the
standoffs and tighten them.
NOTE
Save the cable tie wraps, ribbon cable, and ribbon cable
clamps. You’ll use them when you wire outputs to the TB-
50 and when you connect the ribbon cable.
WARNING
Do not connect power to the CLS now. Test the unit first, as
explained in the Power Wiring and Controller Test section.