Owner manual

Installation
CLS User’s Guide 29
Using the Cable Tie Wraps
When you have wired outputs to the TB-50, use the cable tie wraps
shipped with it. This diagram shows the cable tie wrap holes.
Each row of terminals has a cable tie wrap hole at one end. Thread the
cable tie wrap through the cable tie wrap hole. Then wrap the cable tie
wrap around the wires attached to that terminal block.
Configuring Outputs
•
You can enable or disable the control outputs. The default setting is
heat outputs enabled, cool outputs disabled.
•
You can program each control output individually for On/Off, TP,
SDAC, or DZC control.
•
You can individually program each control output for direct or
reverse action.
1
12345678910111213A
25242322212019181716151413B
262728
29
303132
33
34
35
36
3738A
50494847464544434241403938B
B
B
B
B
A
A
A
A
Holes labeled "A"are m ounting holes.
Holes labeled "B"aretiewrap holes.