Instruction Manual
Watlow EZ-ZONE
®
PM Limit Controller • 61 • Chapter 6 Setup Page
Setup Page
Dis-
play
Parameter Name
Description
Range Default
Modbus
Relative
Address
CIP
Class
Instance
Attribute
hex (dec)
Pro-
fibus
Index
Param-
eter ID
Data
Type
&
Read/
Write
[bAUd]
[bAUd]
Communications (2)
Baud Rate Devi-
ceNet™
Set the speed of this
gateway'scommunica-
tions to match the speed
of the serial network.
[`125]125kb
[`250] 250 kb
[`500] 500 kb
125 - - - - - - - - - - - - 17053 - - - -
[`FC;E]
[ FC.E]
Communications (2)
DeviceNet™ Quick
Connect Enable
Allows for immediate
communication with the
scanner upon power up.
[``no] No
[`YES} Yes
No - - - - - - - - - - - - 17054 - - - -
[P;Add]
[P.Add]
Communications (2)
Profibus Node Ad-
dress
Set the Profibus address
for this control.
0to126
126 - - - - - - - - - - - - 17060 - - - -
[a;loc]
[A.Loc]
Communications (2)
Profibus Address
Lock
SettheDeviceNet™ad-
dress for this gateway.
[``no] No (59)
[`YES}Yes(106)
No - - - - - - - - - - - - 17061 - - - -
[iP;M]
[iP.M]
Communications (2)
IP Address Mode
SelectDHCPtoleta
DHCPserverassignan
address to this module.
[dhCP]DHCP(1281)
[F;Add]FixedAddress(1284)
DHCP - - - - - - - - - - - - 17012 - - - -
[iP;F1]
[ip.F1]
Communications (2)
IP Fixed Address
Part 1
Set the IP address
of this module. Each
device on the network
must have a unique ad-
dress.
0 to 255 169 - - - - - - - - - - - - 17014 - - - -
[iP;F2]
[ip.F2]
Communications (2)
IP Fixed Address
Part 2
Set the IP address
of this module. Each
device on the network
must have a unique ad-
dress.
0 to 255 254 - - - - - - - - - - - - 17015 - - - -
[iP;F3]
[ip.F3]
Communications (2)
IP Fixed Address
Part 3
Set the IP address
of this module. Each
device on the network
must have a unique ad-
dress.
0 to 255 1 - - - - - - - - - - - - 17016 - - - -
Note:
Some values will be rounded off to fit in the four-character display. Full values can be read
with other interfaces.
* These parameters/prompts are available in this menu with firmware revisions 11.0 and
above.
R: Read
W: Write
E: EEPROM
S: User Set










