Instruction Manual

Watlow EZ-ZONE
®
PM Limit Controller • 65 • Chapter 7 Factory Page
To go to the Factory Page from the Home Page, press and hold both the Advance
‰
and Reset
RESET
keys for six
seconds.
• PresstheAdvanceKey
‰
to move through the parameter prompts.
• PresstheUp¿orDown¯ keys to change the parameter value.
• PresstheResetkey
RESET
to return to the Home Page.
Note:
Someofthesemenusandparametersmaynotappear,dependingonthecontroller'soptions.Seemodel
number information in the Appendix for more information. If there is only one instance of a menu, no sub-
menus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon controller part
number.
Chapter 7: Factory Page
Navigating the Factory Page
7
[CUSt]
[FCty] Custom Setup Menu
[```1]
[CUSt] Custom Setup (1 to 20)
[`par] Parameter
[`iid]InstanceID
[`LoC]
[FCty] Security Setting Menu
[`LoC] Security Setting
[LoC;o] Operations Page
[pas;e] Password
[RloC] Read Lock
[SLoC] Write Security
[loC;l] Locked Access Level
[roll] Rolling Password
[pas;u] User Password
[pas;a] Administrator Password
[ULoC]
[FCty] Security Setting Menu
[Code] Public Key
[pass] Password
[diAg]
[FCty] Diagnostics Menu
[diAg] Diagnostics
[``Pn] Part Number
[`rEu] Software Revision
[S;bld] Software Build Number
[``Sn] Serial Number
[dAtE] Date of Manufacture
[ip;aC] IP Actual Address Mode
[ip;a1] IP Actual Address Part 1
[ip;a2] IP Actual Address Part 2
[ip;a3] IP Actual Address Part 3
[ip;a4] IP Actual Address Part 4
[ip;a5] IP Actual Address Part 5
[ip;a6] IP Actual Address Part 6
[`CAL]
[FCty] Calibration Menu
[```1]
[`Cal] Calibration (1 or 3)
[`Mu] Electrical Measurement
[ELi;o] Electrical Input Offset
[ELi;S] Electrical Input Slope
[ELo;o] Electrical Output Offset
[ELi;s] Electrical Output Slope
[ELo;s] Electrical Output Slope
[``Pn] Part Number
[Code] Code