Instruction Manual

PPC-2000 User’s Guide Chapter 3: Operating with AnaWin 3
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 139
System Status
Refer to Table 3.20 for a description of the system status
parameters.
Table 3.20 System Status
Logic Program Controls
Select Start or Stop to control the logic program.
Global Settings
Refer to Table 3.21 for a description of the global settings.
Time and Date
The PPC-2000’s clock calendar automatically updates the year,
month, date, hour, minute and second.
Table 3.21 Global Settings
Parameter Definition
Ambient Status Ambient temperature error
Memory Status RAM verification error
Loop Checksum Closed-loop control program verified
HW Cfg Status Hardware configuration error
Logic Run Status Logic program is/is not running
Logic Load Status Logic program is/is not loaded
Battery Status Battery status
Parameter Definition
Loop Start State
Determines whether closed-loop control chan-
nels are set to Off mode when the PPC is pow-
ered up or reset, or whether the control
channels resume operation in the same
control mode that was active before the PPC
was powered down.
Logic Start State
Determines whether or not the logic program, if
present, runs when the PPC is powered up or
reset
AC Frequency
Determines the input scan duration and DZC
output time base. Set this parameter equal to
the AC line frequency.