Instruction Manual

PPC-2000 User’s Guide Chapter 4: Troubleshooting

Doc.# 30002-00 Rev 2.3 Watlow Anafaze 145

Battery Installation Procedures

Changing the battery on the processor module involves minor

mechanical disassembly and reassembly of the controller.

Appropriate precautions should be taken to prevent

electrostatic discharge damage to the electronic components.

Wear a grounding strap and place components on static-free

grounded surfaces only.

A small flathead screwdriver is needed.

CAUTION!

All control parameters and retained values in the

logic program will be lost when the battery is

removed! Take a Snapshot of the current

configurations in AnaWin3 before removing the

battery.

Be sure to take antistatic precautions.

1. Power down the controller.

2. Remove the power connection to the processor module and

any cables between the modules and terminal boards.

3. Note and label cable locations.

4. Remove the PPC-2000 system from the DIN rail or

panel.

5. Make sure the red top and bottom module latches on the

processor module are in the unlocked position (pushed

toward the back of the module.)

Figure 4.4 PPC Assembled Modules Top View

Module

top

latch

(unlocked)

Back

Front

Module

latch

(locked)

top